Indesit FGI K IX Mode d'emploi télécharger pdf (Page 15)

Ventilation

To ensure adequate ventilation, the back panel of the

cabinet must be removed. It is advisable to install the

oven so that it rests on two strips of wood, or on a

completely flat surface with an opening of at least 45 x

560 mm (see diagrams).

Centring and fastening

Secure the appliance to the cabinet by opening the

oven door and fastening 4 screws into the 4 holes of

the outer frame.

! All parts ensuring the safe operation of the appliance

must not be removable without the aid of a tool.

Electrical connections

! Ovens equipped with a three-pole power supply

cable are designed to operate with alternating current

at the voltage and frequency indicated on the data

plate located on the appliance (see below).

Fitting the power supply cable

1. Open the terminal board by

inserting a screwdriver into the

side tabs of the cover. Use the

screwdriver as a lever by

pushing it down to open the

cover (see diagram).

2. Install the power supply

cable by loosening the cable

clamp screw and the three wire

contact screws L-N-

Connect the wires to the

corresponding terminals,

adhering to the colour code of

Blue (N), Brown (L) and Yellow-

Green

(see diagram).

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Connecting the supply cable to the mains

Install a standardised plug corresponding to the load

indicated on the data plate (see adjacent box).

The appliance must be directly connected to the

mains using an omnipolar circuit-breaker with a

minimum contact opening of 3 mm installed between

the appliance and the mains. The circuit-breaker

must be suitable for the charge indicated and must

comply with current electrical regulations (the earthing

wire must not be interrupted by the circuit-breaker).

The supply cable must not come into contact with

surfaces with temperatures higher than 50°C.

! The installer must ensure that the correct electrical

connection has been made and that it is compliant

with safety regulations.

Before connecting to the power supply, make sure that:

 the appliance is earthed and the plug is compliant

with the law.

 the socket can withstand the maximum power of the

appliance, which is indicated on the data plate (see

below).

 the voltage is in the range between the values

indicated on the data plate (see below).

 the socket is compatible with the plug of the

appliance. If the socket is incompatible with the

plug, ask an authorised technician to replace it. Do

not use extension cords or multiple sockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced

by authorised technicians only (see Assistance).

! The manufacturer declines any liability should these

safety measures not be observed.

Gas connection

The appliance should be connected to the main gas

supply or to a gas cylinder in compliance with current

National regulations. Before carrying out the

connection, make sure the cooker is compatible with

the gas supply you wish to use. If this is not the case,

follow the instructions indicated in the paragraph

Adapting to different types of gas.

When using liquid gas from a cylinder, install a

pressure regulator that complies with current National

regulations.

560 mm.

45 mm.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Indesit FGI K IX Mode d'emploi Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Fours Indesit FGI K IX