Indesit BV 40 L/CS F Mode d'emploi Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 72
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
GB
14
Securing the appliance to the cabinet
There are three different groups of appliance as far as
installation is concerned:
1-Built-in hobs (Class 3) (see Fig. 2, detail H1). In this case
it is necessary to make a hole with measurements
matching those of the hob in the worktop. The
measurement at the side should be reduced by 15 mm so
as to ensure that 7.5 mm of the hob overlaps with and
rests on top of the worktop surface (see figure 3). To fit the
hob flush with the worktop, this worktop surface must be
lowered by a further 1 mm each side (see Fig. 3 and 4), so
that both the edge of the hob and the seal “G” underneath it
can be positioned there.
Before fitting the hob to the worktop, position the seal
provided along the perimeter of the hob, as illustrated in Fig
4. Brackets for fixing worktops to the cabinet have been
provided, and these should be fitted as shown in detail S.
2-Built-in hobs (Class 3) with edges lower than 65/80 mm
(see Fig 2, detail H2). To install this type of hob, a hole
large enough to accommodate the whole lower casing of
the appliance must be made on the worktop intended to be
under the hob. Remember to leave a gap of at least 1 cm
between the lower casing and the worktop around the
whole perimeter of the appliance (the underside of the
casing can, however, touch the surface below it). To fit the
appliances, follow the instructions given above in point 1 or
use any supplementary instruction leaflet that is provided
in special cases.
Fig.2
Fig.3
7.5 mm
1 mm
1 mm
BUILT-IN HOB
HEIGHT= STEEL THICKNESS
BUILT-IN HOB
STEEL TICKNESS <HEIGHT <65mm* - 80mm**
SIT ON - ON HOB
HEIGHT >65mm* - 80mm**
Fig.4
X
Y
Y - 15 mm
X - 15 mm
1
m
m
R 11
X + 2mm
Y + 2 mm
G
X
Y
Y - 15 mm
X -15 mm
* For mod: BV 40... - ** For mod: BV 40 L...
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 71 72

Commentaires sur ces manuels

Pas de commentaire