Indesit KP902GX Mode d'emploi télécharger pdf (Page 7)

Start-up and use

Using the hob

Lighting the burners

For each BURNER knob there is a complete ring

showing the strength of the flame for the relevant burner.

To light one of the burners on the hob:

1. Bring a flame or gas lighter close to the burner.

2. Press the BURNER knob and turn it in an

anticlockwise direction so that it is pointing to the

maximum flame setting

3. Adjust the intensity of the flame to the desired level

by turning the BURNER knob in an anticlockwise

direction. This may be the minimum setting

, the

maximum setting

or any position in between the two.

If the appliance is fitted with an

electronic lighting device (see

figure), press the BURNER

knob and turn it in an

anticlockwise direction, towards

the minimum flame setting, until

the burner is lit. The burner may

be extinguished when the knob is released. If this

occurs, repeat the operation, holding the knob down

for a longer period of time.

! If the flame is accidentally extinguished, switch off

the burner and wait for at least 1 minute before

attempting to relight it.

If the appliance is equipped with a flame failure

safety device, press and hold the BURNER knob for

approximately 2-3 seconds to keep the flame alight

and to activate the device.

To switch the burner off, turn the knob until it reaches

the stop position 0.

Practical advice on using the burners

For the burners to work in the most efficient way

possible and to save on the amount of gas

consumed, it is recommended that only pans that

have a lid and a flat base are used. They should also

be suited to the size of the burner:

!To identify the type of burner, please refer to the

diagrams contained in the “Burner and nozzle

specifications”.

! For models equipped with a reducer grid, the latter

must be used only for the auxiliary burner, when pans

with a diameter of less than 12 cm are used.

! Make sure the pans do not overlap the edges of

the hob while it is being used

Setting the time

In order to use the timer, it must be wound by turning

the "S" knob almost one complete turn in the

clockwise direction

. Then, turning it back , set

the desired time by lining up the number for the

minutes with the mark on the control panel.

Using the oven

! The first time you use your appliance, heat the empty

oven with its door closed at its maximum temperature

for at least half an hour. Ensure that the room is well

ventilated before switching the oven off and opening the

oven door. The appliance may emit a slightly

unpleasant odour caused by protective substances

used during the manufacturing process burning away.

! Never put objects directly on the bottom of the oven;

this will avoid the enamel coating being damaged.

In order to cool down the temperature of their exterior,

some models are fitted with a cooling fan that comes on

when the programme selector knob is turned. In this

case, the fan is always on and a normal flow of air can

be heard exiting between the oven door and the control

panel.

Note: when cooking is done, the fan stays on, even

if knob is set to “0”, until the oven has cooled

down sufficiently.

In "Fast cooking" mode, the fan comes on automatically

only when the oven is hot.

Once you have removed the food from the oven, we

recommend you leave the oven door ajar for a few

minutes: this will drastically reduce the duration of the

cooling cycle. The process is controlled by an additional

thermostat and can consist of one or more cycles.

1. Select the desired cooking mode by turning the

SELECTOR knob.

2. Select the recommended temperature for the

cooking mode or the desired temperature by turning

the THERMOSTAT knob.

A list detailing cooking modes and suggested

cooking temperatures can be found in the relevant

table (see Oven cooking advice table).

During cooking it is always possible to:

• Change the cooking mode by turning the

SELECTOR knob.

• Change the temperature by turning the

THERMOSTAT knob.

• Stop cooking by turning the SELECTOR knob to

the “0” position.

Burner ø Cookware Diameter (cm)

Fast (R) 24 - 26

Semi Fast (S) 16 - 20

Auxiliary (A) 10 - 14

Triple Crown (TC) 24 - 26

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Indesit KP902GX Mode d'emploi Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes Indesit KP902GX