Indesit 3D AA NX Mode d'emploi Page 25

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 60
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 24
GB
25
Respecting and conserving the environment
Install the appliance in a fresh and well-ventilated room.
Ensure that it is protected from direct sunlight and do not
place it near heat sources.
Try to avoid keeping the door open for long periods or
opening the door too frequently in order to conserve energy.
Do not fill the appliance with too much food: cold air must
circulate freely for food to be preserved properly. If circulation
is impeded, the compressor will work continuously.
Do not place hot food directly into the refrigerator. The internal
temperature will increase and force the compressor to work
harder and will consume more energy.
Defrost the appliance if ice forms (
see Maintenance
). A thick
layer of ice makes cold transference to food products more
difficult and results in increased energy consumption.
Regularly check the door seals and wipe clean to ensure they
are free of debris and to prevent cold air from escaping (
see
Maintenance
).
Troubleshooting
If the appliance does not work, before calling for Assistance (see
Assistance), check for a solution from the following list.
The green POWER indicator light does not illuminate.
The plug has not been inserted into the electrical socket, or
not far enough to make contact, or there is no power in the
house.
The motor does not start.
The appliance comes with a motor protection control (
see
Start-up and use
).
The indicator lights are on but the light is dim.
Pull out and reverse the plug before putting it back in the
socket.
a) The alarm sounds.
a) The refrigerator door has remained open for more than two
minutes (the buzzer will stop sounding when you shut the
door) or the correct switching-off procedure was not followed
(
see Maintenance
).
b) The alarm sounds and the two yellow indicator lights
flash.
b) The temperature in the freezer is too high. Check the quality of
the food products and dispose if necessary.
+ buzzer = Heating is excessive
c) The alarm sounds and the two yellow indicator lights as
well as the green one flash.
c) The temperature in the freezer has reached a dangerous
level. The food must be disposed immediately.
+ buzzer = Heating danger
b/c) In the first case the freezer will maintain a temperature of
about 0°C so that the food does not re-freeze. In the second case,
however, the temperature will remain at approximately -18°C. To
turn off the acoustic signal open and close the refrigerator door. To
restore normal operation bring the FREEZER OPERATION knob
setting to
(off) and turn the appliance on again.
The green POWER indicator light flashes.
The appliance is not operating correctly. Contact the Technical
Assistance Centre.
The refrigerator and the freezer do not cool well.
The doors do not close properly or the seals are damaged.
The doors are opened too frequently.
The OPERATION knobs are not on the correct setting (
see
Description
).
The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
The REFRIGERATOR OPERATION knob is not on the correct
setting (
see Description
).
The food is in contact with the back inside wall of the
refrigerator.
The motor runs continuously.
The SUPER FREEZE button has been pressed (rapid
freezing): the yellow SUPER FREEZE light is on or flashing
(
see Description
).
The door is not closed properly or is continuously opened.
The outside ambient temperature is very high.
The thickness of the frost exceeds 2-3 mm (
see Maintenance
).
The appliance makes a lot of noise.
The appliance has not been installed on a level surface (
see
Installation
)
.
The appliance has been installed between cabinets that
vibrate and make noise.
The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
Some of the external parts of the refrigerator become hot
Temperaturile ridicate sunt necesare pentru a evita formarea
apei de condens în anumite zone ale produsului.
Vue de la page 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Commentaires sur ces manuels

Pas de commentaire