Indesit THP 642 IX/I Mode d'emploi télécharger pdf (Page 8)

• Setting the burners to minimum

 

2. Remove the knob and adjust the adjustment

screw, which is positioned in or next to the tap



 

alight, quickly change the position of the knob from minimum to maximum



 





5. Once the adjustment has been made, replace the seals on the by-passes

using sealing wax or a similar substance.

! If the appliance is connected to liquid gas, the regulation screw must be

fastened as tightly as possible.

!        

indicating the new type of gas used. Stickers are available from any of our

Service Centres.

! Should the gas pressure used be different (or vary slightly) from the



inlet pipe (in order to comply with current national regulations).

Electrical

connections

DATA PLATE

ECODESIGN

see data plate

This appliance conforms to the EU Regulation no. 66/2014

implementing Directive 2009/125/EC.

standard EN 30-2-1



Refer to the injector table of you Country

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Indesit THP 642 IX/I Mode d'emploi Page 8